MAIN PAGE » KTM » KTM 1290 » 1290 R/SE - 2014-16 » Rear axle nut in duralumin for KTM 1290/1390 - EVOTECH S.R.L - Orange - Right
Rear axle nut in duralumin for KTM 1290/1390 - EVOTECH S.R.L - Orange - Right
Very high quality duraluminium nut (7075T6) for the right side of the rear wheel.
By machining on CNC - controlled machines a great design and a refined look is realizable.
The 6 bulges and the 6 front holes reduce weight compared to the original without compromising stability. The tightening torque remains unchanged. The assembly is done with a standard ring spanner or nut.
Delivered: Rear axle nut right side with 60 mm wrench size.
By machining on CNC - controlled machines a great design and a refined look is realizable.
The 6 bulges and the 6 front holes reduce weight compared to the original without compromising stability. The tightening torque remains unchanged. The assembly is done with a standard ring spanner or nut.
Delivered: Rear axle nut right side with 60 mm wrench size.
- Manufacturer:
SEVENTYONE S.R.L.
Zona Industriale Palù, 6G - 38055 Grigno (TN)
Phone: +39 0461 780184
info@evotech-rc.it
General safety instructions for the product:
We recommend that you always consult a specialist workshop when fitting our products or have this work carried out by a specialist. If you fit it yourself, please make sure that your motorbike is secure and that the product is only intended for your motorbike. The models for which the product is tested and intended can be found with each item.
To avoid damage to your motorbike during installation, we recommend covering all important/sensitive parts. Please understand that we cannot accept any liability for consequential damage caused by improper installation.
When fitting, use threadlocker if possible and observe the torque specifications. The fixing screws on the licence plate holder in particular should be secured with threadlocker. Loss of the licence plate holder due to lost screws can cause unpleasant damage.
General torque specifications can be found HERE
The legally required licence plate angle of 30 degrees can be set on the Italian licence plate holders
Information for our Austrian customers specifically for the type approval and registration of licence plate holders can be found HERE
Unfortunately there are no reviews yet. Be the first who rates this product.
You must be logged in to submit a review. Login
Customers who bought this product bought also the following products:
This product was added to our catalog on Monday, June 8, 2020.