MAIN PAGE » TRIUMPH » Speed Triple RS / RR ab 2021 » Reflector kit for Evotech Italy number plate holder

Reflector kit for Evotech Italy number plate holder

Reflector kit for Evotech Italy number plate holder
Suitable for licence plate holder from Evotech Italy
Scope of delivery: mounting bracket, reflector

Products Safety/TÜV

Manufacturer:
SEVENTYONE S.R.L.
Zona Industriale Palù, 6G - 38055 Grigno (TN)
Phone: +39 0461 780184
info@evotech-rc.it

General safety instructions for the product:
We recommend that you always consult a specialist workshop when fitting our products or have this work carried out by a specialist. If you fit it yourself, please make sure that your motorbike is secure and that the product is only intended for your motorbike. The models for which the product is tested and intended can be found with each item.
To avoid damage to your motorbike during installation, we recommend covering all important/sensitive parts. Please understand that we cannot accept any liability for consequential damage caused by improper installation.
When fitting, use threadlocker if possible and observe the torque specifications. The fixing screws on the licence plate holder in particular should be secured with threadlocker. Loss of the licence plate holder due to lost screws can cause unpleasant damage.
General torque specifications can be found HERE

The legally required licence plate angle of 30 degrees can be set on the Italian licence plate holders

Information for our Austrian customers specifically for the type approval and registration of licence plate holders can be found HERE

Customer reviews

Unfortunately there are no reviews yet. Be the first who rates this product.

Customers who bought this product bought also the following products:

Reinforced number plate made of DIBOND® material 180 x 200 mm

Reinforced number plate (D) 180 x 200 mm...

Are you looking for a stable and visually clean solution for mounting your number plate?
We offer a 3 mm thick, 150 gram light DIBOND® plate with perfectly rounded, milled corners.
This is identical to the curves of the number plate.
The plate is matt black on one side and glossy black on the other.
For our customers from SWITZERLAND or LICHTENSTEIN we also have the right size in stock: 140 x 180 mm plate
For our customers from Austria we can recommend this plate: 210 x 170 mm

The plate is supplied without holes.
We used 5 mm countersunk screws for mounting on a KTM Super Duke R 1.0.

The holes on the plate were countersunk with a 5.5 mm drill bit and then with a countersunk drill bit according to the screw.
It is best to use a pillar drill with a depth stop for this.
To secure the M5 cap nut we use Loctite 243.
The reflector with the angle bracket is already included with most EVOTECH PERFORMANCE number plate holders. If not, you can get it HERE.
Alternatively, we also offer a higher-quality reflector kit: REFLEKTORKIT

16,25 Dollar